Welcome to visit China Pengwei Machinery website
Flip Flow Screen
Square Swing Sieve
Plate Feeder

Is the deviation of the large-incline belt conveyor the same as the deviation of the flat belt?

Belt deviation of large-incline belt conveyor is also one of the faults that are very easy to occur in the production process of enterprises. The following is the adjustment method for the deviation of large-incline belt conveyor. I hope it can help you.
1. The belt tail shifts to the left/right

Adjust the tail drum, adjust the left side to tighten the lead screw, or tighten or loosen depending on the situation on the spot. In the same way, if the belt runs off to the right, the adjustment method is the same, that is, adjust the head roller in the same direction as the run off.

Is the deviation of the large-incline belt conveyor the same as the deviation of the flat belt?

2. Offset in the middle of the belt
Adjust the middle of the large inclination belt conveyor, adjust the upper or lower idler to make corrections. At this time, the adjustment method is different. If the middle part deviates to the left, adjust the right side of the idler roller and adjust it in the opposite direction. In the same way, if the middle part deviates to the right, adjust the left side of the idler roller to achieve a balanced force on the idler, and the belt conveyor will no longer be deviated.
3. Uneven force
The deviation of the conveyor belt is generally caused by uneven force. ①The tail roller can be adjusted, which side of the roller needs to be tensioned, ②The idler roller can be adjusted for fine adjustment, ③Check whether the feed opening In the middle, adjust the feeding position to prevent deviation due to material impact.
4. Quality issues
If the quality of the conveyor belt itself is problematic, you can load an edge roller to change it. However, the manufacturer recommends that the belt is replaced well. Loading the sidewall roller will cause serious wear of the belt and greatly shorten the life.
The above is the introduction of the deviation of the belt conveyor with a large inclination angle. When the deviation problem of the belt conveyor with a large inclination angle occurs, a comprehensive and correct analysis of the fault must be carried out, and corresponding treatment measures shall be taken within the time. Reduce greater losses, if you encounter any problems during the operation